6 results (0,12054 seconds)

Show all filters

Brand

Merchant

Price (EUR)

Reset filter

Products
From
Shops

Hochiki 2 Pipe Aspiration Smoke Detector with Docking Station FIRELINK-100

Hochiki 2 Pipe Aspiration Smoke Detector with Docking Station FIRELINK-100

Hochiki FIRELINK-100 2 Pipe Aspiration Smoke Detector with Docking StationFIRElink-100 is designed to provide very high sensitivity smoke detection in a small package. A unique sensing technology ensures that the detector operates at optimum sensitivity for the protected environment without the need for complex setup. This means the product will configure itself to provide high sensitivity in a computer room or reduced sensitivity in a smoky area.The detector is designed to fit into a Docking Station which accepts all sampling pipes and cables leaving the detector to be fitted during the final commissioning phase. This ensures that the detector is less likely to be damaged during installation. Volt-free Fire 1 and Fault relay outputs are provided for remote monitoring by local fire detection or BMS systems.Key FeaturesUltra-small low cost aspirating smoke detector for easy and discreet installationHigh sensitivity provided by laser based forward light scatter for reliable early warningTwo sampling pipes up to 100 m aggregate in length still airFalse alarms reduced by unique laser sensing technology - able to discriminate against dustRS485 communications built in as standard for networking and remote communications

GBP 1943.92
1

Hochiki SPC-ET Beam Smoke Detector 5-100m

Hochiki SPC-ET Beam Smoke Detector 5-100m

Hochiki SPC-ET Beam Smoke Detector 5-100mThe SPC-ET is a two wire beam smoke detector that consists of an emitter and receiver that cover a distance of 5 100 m providing a maximum coverage of 1500 m2.When used on a conventional system the emitter and receiver can be powered directly from the zone or if required the emitter also has an option to be powered from a separate 24 V dc supply. The SPC-ET can also be interfaced to Hochikis ESP system the receiver can be connected to a CHQ-SZM2 Single Zone Module or a CHQ-DZM2 Dual Zone Module and the emitter can then be powered directly from the loop or via a separate 24 V dc supply.The SPC-ET comes complete with a termination module which fits directly on to a standard U.K dual back box this allows the detector be surface or flush mounted. Line continuity options can be selected on the termination module and these are based on the Schottky or Zener diode method.Key Features5 to 100 m rangeAutomatic compensationAutomatic signal strength adjustmentEmitter unit can be powered directly from zone or loopFeatures a Latching or Non-Latching Fault RelayCan be interfaced onto ESP system via a CHQ-DZM or CHQ-SZMFull line continuity optionsApproved by LPCB VdS

GBP 466.00
1