SAS Caring Technology Touch-Wireless-CP Touch Wireless Call Point with Call Level No Reset
SAS Caring Technology Touch-Wireless-CP Touch Wireless Call Point with CallLevel No ResetDesigned for challenging environments. The room unitmanufactured from injection molded Tritan Tx more resilient thanPolycarbonate is low profile and vandal resistant. The unit is touch buttonactuated and any of the above configuration of active buttons can be achieved.The patient touches the area denoted by the orange paddle to activate a patientcall. The hidden LED in the centre of the call point illuminates red when thebuttons are touched. A low battery warning will sound when the battery is low.Upon detection of a low battery a CALL signal is sent out this will not besent again until the battery has been changed. While the room units battery islow it will continue to flash its red LED every 15 seconds and sound its buzzerevery 2 minutes. Staff should be made aware of this. The buttons in the framestaff only can be used by the nurse to reset the call. Included 2x torx M3.5x 25mm security screws 3 x AAA batteries surface back box optionalThe wireless call points are a cost-effectiveapproach to add nurse call to an existing staff attack system. This helps keepdisruption to a minimum since no walls need to be chased and are easilyinstalled with an anti-ligature surface collar. The slave wireless call pointsyncs with a master IR receiver which is addressed to understand its location.
